Superior foam to remove organic pollution
Superior foam to remove organic pollution
In order to remove stubborn dirt and organic material, such as plant juices, using an optimally formulated cleaning agent such as Intra Clean Organics is essential to ensure optimal biosecurity.
In order to remove plant juices and organic material, using an optimally formulated cleaning agent such as Intra Clean Organics is essential. The surfactants ensure IntraClean Organics cleans deeply into the surfaces and the sequestrants ensure optimal and quick efficacy. Additionally, Intra Clean Organics has a high adhesive capacity by the optimal foam formation, guaranteeing a maximum contact time with the polluted surface. This allows the active components to intensely dissolute and remove all pollution, especially on vertical surfaces. Cleaning with Intra Clean Organics is the excellent pre-treatment for later disinfection with Intra Multi-Des GA.
When should I Use Intra Clean Organics?
Intra Clean Organics is used for removal of organic pollution, such as plant juices, plant rests and algae. Soak the surface with a foam of Intra Clean Organics and make sure to rinse the surface after with clean water to remove the released dirt.
What concentration should I use?
The advised concentration is 2% Intra Clean Organics. With this concentration the foam will be of optimal quality.
What is the function of the foam?
With foaming products, it is important to have the optimal balance between wet foam (much liquid between the bubbles) and dry foam (almost no liquid between the bubbles). If the foam is too wet, it will run off the gutters very quickly and the contact time is too short. When the foam is too dry, it will not have enough water to transport the active ingredients to break down the pollution and therefore contact time is insufficient.
What is the shelf life of Intra Clean Organics?
24 months.
Is Intra Clean Organics corrosive?
Intra Clean Organics can be corrosive for gutters when not rinsed. Always remember to wash off the product after maximum of 12 hours. When higher dosages of the product are used than recommended, rinse the product of within 1 hour.
What is the effect on different material types?
Intra Clean Organics has no corrosive effect on materials as long as the recommended dosage and contact time are guaranteed. If these are exceeded, pay special attention to aluminium surfaces.
What equipment should I use for Intra Clean Organics?
To have the best foaming properties it is best to use a foaming gun on a high pressure washer. For easy daily use the Intra Hygiene Trolley would be recommended.
Should I use cold or warm water?
Intra Clean Organics can be applied and washed off with cold water.
+31(0)413354105